|
TMBbutch Apr 23rd, 07, 6:49 PM hi... guys.....i saw one day that there was a manufacturer that made the... peices to weld to the bottom of your stock lower control arms. to box them in. I cant find the link.....any help......thanks..Butch C652 Apr 23rd, 07, 6:59 PM Hi Butch, I did mine with 1/4" flat stock, be sure to measure length right as if they are to long they will interfere with the mounts, Hope this helps Jerry Xtreme70SS396 Apr 24th, 07, 12:10 AM It wasn't really a "manufacturer" so much as a moderator here in the wagons forum, Pete Lohr. His site is www.einstyn.com. Link:http://www.einstyn.com/einstyn-hardtop-05.htm BillsCamino Apr 24th, 07, 7:31 AM Butch, Are you inquiring about boxing front OR rear control arms? :confused: I was thinking you meant rears... SS70ElCaminoOwner Apr 24th, 07, 9:03 AM Rears = http://www.leverfamilysite.com/Boxing_Lower_Control_Arms.htm :waving: Sams454SS Apr 24th, 07, 10:26 AM TMBbutch, This is what you're looking for. It is for 64 to 72 chevelles to box in the rear lower control arms. Welding required. Look at the right hand side of the page once it loads up. http://www.opgi.com/product.asp?topcatid=28&chapterid=796&topvalue=0&newflag=0&grpcode=14889&yearrange= Sam SMilligan Apr 24th, 07, 10:38 AM Groundup or NPD also sells the inserts. I welded mine in from there. Not a big deal but make sure you measure the spacing for the sway bar and tack the inserts in place and measure again. The inserts can be stretched a bit and may be to tight for the bolts to line up after you weld. | ||