Hey fellows,

Got the Chevelle sealed with epoxy last night and will try to get the color and clear on her tonight.

While spraying a few test panels, I shot a panel with the color coat (PPG Deltron) and the one half of it with some Dupont 7900S clear thinned about 10%.

After that dried, I taped it off and shot the other half with the SPI Clear that I bought for the project. I didn't thin the SPI clear per their instructions and, I can't get it to come out nice and slick like the Dupont clear.

Can I thin the SPI to help it flow better?

Thanks

Yes, you should thin it a 'bit.

I would check here.. on the spi forum.

http://spi.forumup.org/index.php?mforum=spi

You should go over to the SPI forum and ask there. There are lots more people there that use it on a daily basis. Not trying to push you outta here, I just think you'll get a better answer from over there.

http://spi.forumup.org/forum-7-spi.html - unversal Clear forum