I am planning on the LS1 rear brakes.

Do I need to have the axles turned down slightly to fit in the rotor (both the center locating hub and the outer diameter of the flange).

Anyone know the dimensions? I wanted to order new axles from Moser, but I need the specs...

Thanks...

Tony

center hole measured 2.780, and the inside of the hat is a little bigger than 6"... how much, I don't know... my dial caliper only goes to 6", and it doesn't reach in there anyway. :)

center hole measured 2.780, and the inside of the hat is a little bigger than 6"... how much, I don't know... my dial caliper only goes to 6", and it doesn't reach in there anyway. :)

Damn that was a quick response... You must be on here all the time (no wonder no one can catch up to your post count...).

So as long as I am under 6" overall...

Maybe I won't need new axles afterall (since their older, I'd probably replace rather than just turn them down)...

post count, hell... no wonder I never get any work done. ;) :rolleyes:

I have the Moser axles and the stock LS1 rotors fit.

I have the Moser axles and the stock LS1 rotors fit.

Just "stock" moser axles?

Cool :cool:

guys - I just slid an ls1 disc over my axle tonight - it's the center hole that needs to be clearanced for. The main flange is fine....

PS - I think I've found the solution for the ebrake lever - looks like I can section 3/8" from the lever and weld it back together and I think it will clear the LCA mount on the narrow 12bolt.... more to come....

center hole measured 2.780, and the inside of the hat is a little bigger than 6"... how much, I don't know... my dial caliper only goes to 6", and it doesn't reach in there anyway. :)

would that be the same diameter as my 70 chvelle
the 2.78 center
thanks