|
DragRacer May 25th, 00, 8:39 PM Guys, How is the LH side inner fender intended to attach at the firewall on a '71 Chevelle. Thanks, Jason Gore AKA DragRacer jgchevelle@aol.com rick May 25th, 00, 11:19 PM jason 2 bolts with large fender washers. Right about in the middle of the panel. A couple of inches apart. Check your email http://www.chevelles.com/forum/smile.gif. ------------------ Rick 72 El Camino (http://members.home.net/jimmy4/rick1972elky.html) TPI350/700r4 TC#00038 ACES#00140 JSL May 26th, 00, 6:40 PM It bolts on exactly like the right side. But kinda like looking in a mirror. Jeff Litka 72 Chevelle SS 72 MonteCarlo DragRacer May 27th, 00, 2:58 PM Guys, That's what I would think but there is a bracket welded to the inner fender and the firewall. There are no bolt holes. The RH side goes on exactly as you described, but the LH side ?????? Anyone seen this before? It doesn't look like it is something that is added on by someone. Thanks, Jason Gore AKA DragRacer jgchevelle@aol.com JSL May 28th, 00, 7:27 AM There shouldn't be anything welded anywhere as far as the inner fenders to firewall are concerned. they should bolt up exactly like the other side. Everything on that nose should bolt on. It sounds like some one snapped off the bolts in the bracket on the firewall , then welded it to re attach it. Also keep in mind that these cars came with plastic inner fenders also. DragRacer May 28th, 00, 7:58 PM Guys, I knew the car had been hit slightly on the LH side as the fender was pretty beat up when I stripped it down. Evidently when it was hit it ripped the spot welds out of the bracket. I welded it back on, gave it a coat of paint and it's good as new. Thanks, Jason Gore AKA DragRacer jgchevelle@aol.com | ||