I bought a 72 chevelle a year ago and I have been restoring it. Some body before me, ground off some of the windshield molding retainer pins. I have"nt seen any replacments in any magazines. What is my next step, do I use small nails or some screws, or is there a better way to replace them.

You can CAREFULLY drill and install a n 1/8 inch rivet where the nail would go.
Gordon

I used screw in studs like these Trim Studs (http://www.chevelles.com/showroom/trimstuds.jpg) from Mr Gs(part# fa3039). You may find them at some paint and body supply jobbers.

------------------
Elcaminos are special!
I'd rather walk around with a Chevrolet hubcap in my hand than drive a Ford

Ole Paint (http://www.chevelles.com/showroom/olepaint1)

Big James is right on.

For those who don't know. Mr Gs Fasteners in Fort Worth Tx had dang near any GM fastener you would ever want. Sells em in kits or one at a time. Here is the URL
http://www.mrgusa.com/index.html



------------------
Texas_Tom 69 Coupe in progress, in progress, in progress ....

Super site guys! I only wished they had my car http://www.chevelles.com/forum/frown.gif That's what I get for being into the bastards http://www.chevelles.com/forum/biggrin.gif

------------------
1965 Buick Gran Sport Convertible
1965 Buick Skylark H/T
"Fan of most anything that moves human beings"

dadysquig@yahoo.com

You can buy from Mr Gs, just know exactly what you want.
I asked about the availability of stocked clips for my 65 Chevelle for front and rear glass. (I tried to expalin twice what I wnated in case I didn't expalin it properly)

Response:
My answer is still the same as in my last answer. "I don't know the >information you ask for". I only have the clips shown
> > on my website. The pictures are actual size. That is as good of >help as I can give you.
> >
> mrgs

>Glenn,

Not bashing, just posting actual response.
So do your homework first.
jack