Just acquired a 66 project (rough)that has been 4 linked and need to locate resources parts, info etc ... about trunk floors, panels, kits as theres not enough metal left to build from or on? I thought id'e come to where the experts should be? All input is appreciated!

Do you want to return this to original? A parts car would be your best option. If the aftermarket 4 link is to stay in the car the original sheetmetal will not fit. Another A-body for a donor floor and frame section would be the way to go.

Thanks for the reply! I'm wanting to locate fairly priced kits or panels to finish off the work done. To enclose/cover the 4 link & to finish the pro-street look.

I've bought such kits/panels for 1st gen Camaros & Novas thru jegs but was hoping the Chevelle enthusiasts on this site would lead me to other resources for cost/comparison? Thanks in advance for any info!

Do you access to a Brake?? I re-did all of my rear flooring and tubs on my car. It wasn't very difficult. It's a matter of making cardboard templates and tranfering them to sheet metal (steel or alum) I think most of the kits out there are pretty generic anyway and you'd have to cut and trim them. I want to say I did my trunk floors and divider wall with a 4'x8' sheet of aluminum. Plus I bought the tubs from Jeg's. Just a thought for you. If you have any other questions shoot me an e-mail!