I need a little help and/or recommendations for r/r on this rear sheet metal section for a '72 Chevelle SS. The bumper brackets bolt up to this piece and the bottom portion is badly rusted. I cannot find a replacement piece at Ausley's, Ground Up or any of the other suppliers I have checked. I can fabricate and weld new sheet metal in if that is the best or recommended approach, but obviously it would not approach stock appearance. Any ideas?

I would start looking for a donor car if you want too replace the entire piece, however, you can also just patch the areas that need attention! Hope this helps.. Good Luck

------------------
X-Ray View of my Chevelle :D (http://www.normieschevelle.com/sideview.jpg)
Getting Closer (http://www.normieschevelle.com/passfull.jpg)