|
Freddy Mercado Aug 11th, 02, 1:01 PM Well guys, I finally got the left side floor pan in. Boy was it a lot of work!! The only problem was that the gully where the flat harness runs, is not deep enough to rest upon the frame bracket. We did some banging and it worked. http://www.chevelles.com/forum/biggrin.gif ------------------ WayneK Aug 13th, 02, 10:16 AM Alright Freddy. You'll find you my have to do alot of little freindly banging here and there to meet up the old and new pans. I have a bag of old tire chains the I use to SEAT and keep preasure on the pans while welding in. GL ------------------ Wayne ACES# 1556 TCG # 186 Chief Aug 13th, 02, 11:49 AM My pans were so mismatched from the new floor supports that I bought I had to first BOLT them together to get them close enough, then welded. Came out OK, but wish it could have been better. But, If anybody gets that close to looking he will have been hit by the front bumper anyway. ------------------ "What I need is an exact list of specific unknown problems I might encounter." Team Chevelle #858 A.C.E.S. #...52hundredandsumthin"http://hotred66ss.homestead.com | ||