I haven't used it for a while and no mix ratio on the can for use as a sealer. No need to tint. All I have is K36, DT870, and K201. Will they work? Also while we are at it what is the ratio for a surfacer?

Thanks in advance Bill

http://www.ppg.com/cr-refinish/phase1/frmFindProduct.asp

K36 must be tinted when used as sealer. Or you can sub in one clear, I believe its clear 2021.
4:2:2:1
4 parts K36, 2 parts of DMD/DCC or 2021, 2 parts dt reducer, 1 part DCX8

Mix k36 5:1:1/2 as a surfacer
When mixed 5:1 you have a very short potlife, but you have the most build. Adding that half of DT reducer extends out the potlife just enough but yet doesnt change the build all that much

Thank you both, Mike what a great site.

Bill