I found a little rust on my left front floor pan and plan on replacing it. I have a few question. Its a 67 Chevelle. The rust is in the left front in the gully where the wiring harness runs to the back. Should I replace the entire left front or just the front half? Also, where is the best place to get a quality pan, with the tabs that hold down the wiring harness? Can anyone help?

------------------

I'm not sure exactly where your talking but mine was pitted just in front of the drain hole or whatever that is. I bought a patch panel, cut out the bad area and cut the panel to match then butt welded in.

Worked great I can use a full patch if I keep it long enough to have another problem and I had enough left over to patch the butcher job the guy before me did on the doghouse (hump) when it had a manual trans.

Cutting the patch idea I got from another TC member SEVT_CHEVELLE ,thanks again