ok i so i recently just purchased all new seat covers from Harmons which are made by PUI and i was wondering how hard are they to install? and do i need to get new hog rings or should i just use my old ones? or can i staple it or wut? thanks in advance!
-Andrew
P.S
I have Front Bucket Seats Covers and Rear seat covers

Im surprised you havent got repremanded yet. Before postong a question, you had better try a search.. Allittle effort... But, get new hog rings, hog ring pliers, and photos of there placement is important because you will never remember where thay go.. all this info and more is here ..look... good luck phil

Don't forget to keep the wires from the old covers if the new ones don't have them.

When I did mine, a local shop just gave me a handful of hog rings and let me "borrow" the pliers.

I started on the rear bench seat. I used side-cutters to remove the old rings. Try to remember where they go or take a couple pics.

Don't pull to hard on the PUI covers. That's what I used too.

I also bought some new burlap and attached that to the seat frames under the foam.