Has anyone ever replaced this piece on a 67??? If so, was the repop piece a good fit??? This is becoming a problem for me. :mad:

I have not done the new goodmark panel on 66/67 Chevelle but have done two of there 69 camero tail pans.. IMO the fit was like most Goodmark panels and needed some attention to your fit B-4 you weld.

call johns classic cars in douglasville, ga you can get a used one for $25.00 will fit like a glove . john is a goodmark dealer local #770-920-8675 out of state 1-800-335-4571 www.Ls6454.com (http://www.Ls6454.com) smile.gif

I used a Dynacorn panel and it wasn't bad. Trunk lip wasn't quite the same as original though and had to be modified. Location of the keylock hole was also a smidge too high... Take care of these and it's a good fit.

Mike S.