OK.. 70 chevelle buckets. I need to know how the brackets(sliders), mount. I can see the handle going to the outside but where does the wire attach. does it go accross to the other side? are the two holes on the brackets facing front and the one hole to the rear? A photo looking at the bottoms would help.. Please. If possible I need this info today because Im moving and I might not be able to log on for awhile.. Please help asap.. phil

Here are a couple pictures that I hope will help. I am currently redoing my 70 bucket seats right now.

I believe that the two holes are facing the front.

OK.. 70 chevelle buckets. I need to know how the brackets(sliders), mount. I can see the handle going to the outside but where does the wire attach. does it go accross to the other side? are the two holes on the brackets facing front and the one hole to the rear? A photo looking at the bottoms would help.. Please. If possible I need this info today because Im moving and I might not be able to log on for awhile.. Please help asap.. phil

Hey Phil,

I think I gave you bad advice, I went down to look at my seat bottoms and it appears that the two holes in the bracket goes on the back of the seat. I also cross referenced this from a magazine article that I have.

Sorry for any problems this may have caused.

Bart

ok thanks.. two holes to the rear.. The bracket without the handle,inside track, the wire attaches up to itself. not across to the other side... Merry xmas,thanks phil