I recieved the seat sliders last Sat. and installed them on the seatAfter installation, I noticed that the sliders have one hole in the front and two holes in the back.I am assuming that unless the passanger is to adjust the seat that they won't work.My car,a 67 Malibu came with a bench seat verified by the 761 on the cowl tag next to the Trim Option,but the car has two holes in the front and one in the back,per side.What do I do?As far as I know the floor has never been replaced.When I bought the car,however,it did have buckets out of an Oldsmobile.All of the holes in the floor are threaded and appear to be placed by the factory. What do I do now?

Sounds like you might have a set for 68-72? Their bench had one mount hole in the front and two in the back.

Just curious, are the sliders on 67 and earlier cars interchangable from bench to buckets? I know the 68 to 72 sliders are different lengths. I also thought the bench seat car floorboards were tapped for one slider on each side and a bucket seat car was tapped for two on each side.

i took them out of a 67, eric13617 that way i thought there would be no problems.i will look at all my cars and see if there are different ones.

John thanks,got the seat in the car ,works great.Not your mistake.It was mine.