|
cjski01 Nov 20th, 06, 9:25 AM NPD offers 2 different full quarter panels. It says that 1 is made by an original GM press and that the other is an imported repro. Has anyone ever used the imported one yet. It is quite a bit cheaper, I was just wondering how close to an original it is.. LateNight72 Nov 20th, 06, 11:43 AM It's not that bad. But compared to the OE tooling quarter it's not good. The OE tooling 1/4 is much thicker metal, it fits better, and once installed feels like a original 1/4. So basically, go with the OE tooling quarter. IF they still have them. They were discontinued a while ago.. -Todd 67shovel Nov 21st, 06, 9:22 AM Don't try to save money on replacment sheet metal. Buy the best you can find and or afford. | ||