I posted this earlier but did not get a reply. (or didnt check in time with the search not working) If your replied the first time please do so again.

As I am removing the fenders and interior panels I am noticing the inside door skin passenger side only has rust on the inside about 1/3 up. The thick black coating is laying in bottom.

Can I spray some corrless on it or do I need new door skins? I cant sand what looks like surface rust in there.

Please, dont let my question die again http://www.chevelles.com/forum/frown.gif

[This message has been edited by chris71 (edited 01-23-2002).]

alright. two conditions, 1) if the door is off the car 2) if the door is on the car. 1) sand blast it with low pressure, use por-15 metal clean then metal ready then por-15. it will never rust again. 2) reach in with steel wool or a wire brush or sandpaper. get it as good as you can. then apply por-15 products as stated above. if you have any thru rust holes weld new patch pieces in, sand , prime , paint. i would not replace the door skin unless it has rust all the way THRU a large portion of the skin.

------------------
1970 Chevelle 454 Wagons haul A$$ in style! "The Chopped Suburban". to see some goto
www.EINSTYN.com (http://www.EINSTYN.com) FO_FDYFO = four-fifty four! TC#1460, VCEA#2

I'm a reefer (trailer refrigeration)tech and body work is new so I worry about everything I run into. Thanks for your help.
Chris