Ok guys, Ive got some major issues with my trunk pans in a 69 2dr.... the center all the way to the 2 braces are rusted so bad I could tap it with a hammer and it would drop, however from the braces out is still decently strong, but rusted. it is also rusted half way up the slopes on the rear bumper area and up towards the back seat.

What I need help with is near the fender and wheel well is needing to be removed but it is still somewhat solid... and on top of the fact that I dont have but a jigsaw type cutter w/ metal cutting blade the previous owner slopped JB weld all over the seams near the wheel well.

How can I get the trunk pans as well as the metal that runs from the bottom of the quarter panel to the trunk pan out without cutting up anything I dont need to cut?

(I will try and post some pictures when I get home from Work)

If it's rusted as badly as you say, I would just go ahead and replace the entire floor. The best way is to get a complete replacement panel, and then remove the old one by cutting grinding or dirlling out the factory spot welds.