I have a '72 that needs to have the rear bumper replaced. I took out all of the rear lenses and found the 4 bolts corresponding to the chrome caps on the bunmper. My question is are these the only 4 bolts that hold the bumper in place and do I have to remove the plastic taillight assembly in order to get to the 2 rear facing bolts? And if so, are the 2 bolts,per side,inside the trunk the anchor for these light pods?

if memory serves me.. On my 71 the only bolts I needed too remove were the four inside the trunk... and the two screws holdint the valence near the license plate.. Don't forget about the wiring harnesses!!!!

------------------
X-Ray View of my Chevelle :D (http://www.normieschevelle.com/sideview.jpg)
Getting Closer (http://www.normieschevelle.com/passfull.jpg)

the 2 on each side inside the trunk, 1 or 2 in the middle above the liscence plate and 1 on each side under the bumper that holds a bracket to the body. take the lower brackets and upper brackets off with the bumper. its easier that way. dont forget to unplug the liscence plate bulb wire. it has a disconect.

------------------
1970 Chevelle 454 Wagons haul A$$ in style! "The Chopped Suburban". to see some goto
www.EINSTYN.com (http://www.EINSTYN.com) FO_FDYFO = four-fifty four! TC#1460, VCEA#2

[This message has been edited by FO_FDYFO (edited 01-29-2002).]