I'm about ready to put in the driveshaft for the first time...

Not the original shaft, nor the original tranny - started out with nothing so I'm making this up as I go along.

Got a shaft and pulled the TH350 yoke off it. Now, need to get one on each end. Question is, what do I ask for, who does it and what should I expect to pay? I'm totally in the dark when it comes to driveline issues - never dealt with them before.

This is a 454 if it matters, TH400 and (for now) a stock 2.56 12-bolt rear end...

I know theres a lot of different yokes out there, but as I say...what should I ask for and where?

You can probably call an engine machine shop. I know that "Valley Ballancing" in Ceres charged me $38 for a used 700R4 yoke and then shortened and ballanced the drive line, and added new Spicer u-joints for under 100 total.

bump... anyone with a part suggestion?
Is there a difference betwen different yokes for a TH400?

Beuhler...?