Dave
Oct 21st, 06, 2:57 AM
Just finished installing my new UMI single adj. lowers, Edelbrock uppers with wolfe bearings.
Trans: got 3* on one cap, rotate the driveline 90*, and measure 6* = 3* downwards angle.
Pinion: got 3* on one cap, rotate 90*, and measure 6* = 3* upwards angle.
Looking at GMJim's post it seems that I got it correct, what ya'll think?
Also, somehow, and I'm not saying anymore, got my upper arms out of whack.:clonk: So I got out my tape measure, and just set them both to equal length, then re-adjusted my pinion angle, keeping them the same length this time.:thumbsup: Oughta be good to go, yeah?
Trans: got 3* on one cap, rotate the driveline 90*, and measure 6* = 3* downwards angle.
Pinion: got 3* on one cap, rotate 90*, and measure 6* = 3* upwards angle.
Looking at GMJim's post it seems that I got it correct, what ya'll think?
Also, somehow, and I'm not saying anymore, got my upper arms out of whack.:clonk: So I got out my tape measure, and just set them both to equal length, then re-adjusted my pinion angle, keeping them the same length this time.:thumbsup: Oughta be good to go, yeah?