I just installed a new Edelbrock RPM intake with a Holley 4160 Carb. I used the Holley chrome dual feed line and planned to screw in a fuel pressure gauge in the threaded hole. Problem is the hole points downward to the intake and with the gauge installe is millimeters from it so it would be unreadable. Surely I'm doing something wrong since Holley would put that hole so that it causes the gauge to be unviewable.

Anyone have any ideas on what went wrong here?

Thanks,

Cary

which way is the fuel inlet facing? towards the fire wall or front?

Neither. They are facing the passenger side.

Can you post a link to a picture of your setup?

Nevermind. I put a 90* 1/8" male to female brass elbow on it and all's good now.

Thanks for those that replied!