What do I need to install the tail light Bezels correctly? Gaskets, seals etc...Is there only one seal I need? or more?? Thanks..I have looked in the OPG catalog and all they offer is the 67 Taillight Bezel to body seal part number C990105. Please let me know, so I do it correct the first time...

Yes, you need a sealer/gasket. It resto outlets have them.

Thanks...So what you are saying is that I only need that one part which is the gasket correct? I am also buying the actual tail lamp gaskets as well, while I have it off... Please let me know.

I still need a firm answer on this..What do I acutally need? Just the Gasket, correct? Do I need anything else to complete the job?

Ok, there is a gasket from the light lense to the tail housing, also the factory used a rubber seal that ran on the inside edge of the bezel, then there was also some of that playdo kinda stuff that went around the studs that bolt the housing to the body. Honestly my car doesnt have the one from the bezel to the housing, my original ones were to rotted to use and at the time (dont know about now) they didnt make repops, i have had no ill effects from not using them. hope this helps