installing carpet has anyone any hits on the best way to do this[cutting, measuring glueing?]I bought the carpet through paddock

If you bought molded carpet it is a snap! Lay the carpet out where it is at least room temp. for a couple days. It will then fit right in. Mine came from NPD aand it fit great!! Iam taking for granted that you have the seats etc. out? I only had to trim a little next to the scuff plates. You shouldn't have to glue it. Good luck any problems e-mail me. Slime

------------------
Steve

Get your carpet layed out where it goes with all your seat mounting bolts and seat belt bolts in place and cut an x on bolt head and push down,this is easier than trying to find the holes later!

Ty:

Lay your old one over the new one and just cut to same dimensions, bolt holes, etc.


------------------

tye, if you bought the premolded carpet the only cutting should be for the two balls in the floor that the gas pedal snaps onto. Ther should be a hole with a grommet for the low/high beam switch. Good Luck, Rick