|
Tomb7us Jan 28th, 03, 4:52 PM To my earlier post when i removed the heater fan and looked in i could see a hole back there. I opend up the glove box and looked back and you can see the small hole. Can this be cut out and welded in while its in the car?? what kind of precautions do i need to take to protect my car.? Professor_SS Jan 28th, 03, 5:27 PM How big of a hole? could you go to Lowes, get one of those push in platic caps and fill it. I used them for the misc small holes in my firewall. Look good, can be removed if needed. ------------------ Rick Smith 72 Chevelle and a 70 Chevelle with a crushed roof, soon to be replaced. ACES # 4051 MCC # 448 TC # 1549 81/70 Cruisers Tomb7us Jan 29th, 03, 1:37 PM its a rusted out area not an inch tall but about 2 inches long Professor_SS Jan 30th, 03, 7:42 AM Ouch, sounds like a cut and weld job http://www.chevelles.com/forum/frown.gif ------------------ Rick Smith 72 Chevelle and a 70 Chevelle with a crushed roof, soon to be replaced. ACES # 4051 MCC # 448 TC # 1549 81/70 Cruisers SS_Dave Jan 30th, 03, 1:58 PM If you are not pulling the heater box out to fix it, just fiberglass it and paint. When you put the patch on, cover it with a piece of saran wrap til the epoxy cures. When yo peel the plastic wrap off, it will leave a nice shiny surface. You will probably have some wrinkles if you can tolerate that. Otherwise, pull the box and replace it. I wouldn't weld it in the car. Dave Tomb7us Jan 30th, 03, 4:07 PM I didnt plan to take the heater box out ill look at it. What do i need to do to remove it? | ||