Hi!

Does anyone of you guys have a primaryfuelbowl for a Holley 4165 DP spread bore (list 6213) on a shelf somewhere? Or a whole carb for that matter? Or other suggestions on a fitting fuelbowl? Aaaand who'd like to ship it to Sweden.
It might not be the correct forum but since I asked for suggestions I hope it's OK with you.
B.R.
Pelle

Here's something that might help...
You should have the side hung float bowls on there right now but what I would do is toss those bowls and snag yourself a pair of Center hung float bowls. They'll bolt right on and have a larger capacity, which the 800 spread bore can really use, and they look a lot cooler.

I COULD be wrong...BUT- the 4175 Holley will not allow you to swap bowls with conventional Holleys. Since the 4165 is also a Qjet replacement, I would be it is the same way. It is a different carb in regards to holes and such on the primary side of the carb than a 4150 or 4160. The rear bowl is fine, but the front bowl is the one that causes the problems.

Actually, it's a very easy swap. The holes are the same as far as where the fuel bowl screws are concerned. The 4165 & 4175 can both be fitted with the Center Hung float bowls.