69 repo. drip rail moldings? [Archive] - Chevelle Tech

: 69 repo. drip rail moldings?


TC
Jun 29th, 03, 2:31 PM
Are they any good?
Also is it wise to put these back on before the paint or wait untill after the paint?
Somehow I have one that goes on easy , the other doesnt seem to fit very well thy both have small dents? :(
So..... I though I would just buy new ones if they fit? :confused:
any help/advise will be welcome.
T.C.

troy-curt
Jun 29th, 03, 3:59 PM
TC,
The replacements that I`ve used was pretty good.
If you get some that don`t fit good, send them back.

I paint first.then very carefully install them.
If you mask them real good ,you could leave them on.

If you paint first,have someone help. Like a blond in a G string lol. HTH. Troy. graemlins/clonk.gif

TC
Jun 29th, 03, 4:38 PM
Thanks for the reply Troy:
I will order from Year One cause I know they will take them back if needed. I tink I will paint first and mabe grease :eek: the rail before I assemble.
Sorry but I only have a brunet to help. graemlins/beers.gif
T.C.

troy-curt
Jun 30th, 03, 10:42 AM
TC,
I don`t think I would grease the rails, as grease would ozz out for a long time, on to the paint.
I don`t see it helping installation any.

Troy,

TC
Jun 30th, 03, 4:14 PM
Yea, probably stain the paint also? graemlins/clonk.gif
T.C.

70isfine
Jun 30th, 03, 8:14 PM
A little dish soap on the rail helps and wont hurt anything.

TC
Jun 30th, 03, 8:23 PM
That sounds like a winner!
Thanks to all!!!! graemlins/thumbsup.gif
T.C.