Hey all, it has been a while since I posted. I have been busy on dad's 53' 5 window P/U we have the doors stripped to bare metal and then etch primed with epoxy over them. We did all the filler work over the epoxy and I now have several small areas that I am going to etch again since they are bare steel again. My question is should I Epoxy the enter door again, ie.. over the filler before I put on the K-38 2K surfacer or am I sandwiching and should just go staight to the surfacer ie.. K-38? Thanks a million. Zach

You can do it either way, one to two coats of epoxy then the urethane surfacer would be best IMO. The epoxy is a far better sealer and moisture barrier than K-38. Your truck should last forever.

Thanks Bob, My dad usually keeps vehicles about that long smile.gif This sure is the labor intensive way but hopefully it will be the last time. graemlins/beers.gif