I've posted a similar note under "El Camino", but thougth this forum may be more appropriate. My low beams don't come on. I did a continuity check and found my dimmer switch to be bad, top pin to lower left no continuity. I can click the switch and the high beams come on, click again and all lights (other than parking) go off, click again to get high-beams. Understand that there is no fuse or relay in line from the floor switch to the lights? That there is a bulkhead connection that could be loose? Also, from the other forum someone suggested that even if all 4 lights come on in hi-beam, that the low beams could be burnt out?

On the switch I'd like to verify which wires (4 of them) go where (which is hot, low beams, hi-beams). Two of the 4 wires go to one of the 3 connections on the plug.

thx for any help and thanks to those who replied in the other forum.

Larry

ps: are there any wiring prints on the web?

ps: are there any wiring prints on the web?

http://elcaminocentral.com/article-114-thread-1-1.html