I could not find a classified area on this site. I am looking for a passanger side 70 fender front,( just the area were the fender meets the extention and 4 inches back with the sheet metal bracket that bolts to the core support)

Any help would be appreciated
Tom S

You want just a piece of a fender?


for ads page go here (http://chevelles.com/ads/index.shtml)

Dean,

I am having a hard time finding a 70 elcamino fender, but I have a good 72 elcamino fender and by drilling out the spot welds I can swap the mounting area of a 70 chevelle fender into the 72 elcamino fender. All I need is the front few inches cut from the 70, it can even be from a dented and damaged fender as long as the metal that the front of the fender wraps around is somwhat intact I can make it work.

what about the side marker lights ?

Dean,

The side markers are only cut outs with a rounded over edge and mounting tabs. I can make them but that area would also help if someone had it. Do you have an extra bad fender? If I don't find the parts soon I will have to make the fender front from what I have.

I would be willing to trade some of my extra C-3 Corvette parts for elCamino/ Chevelle parts. I have a long list of elcamino parts I need for this project and a longer list of extra Corvette parts that I have collected over the years.

Tom S

I think the metal is recessed around the cutouts but anyway Yes
I do have one that is rusted badly in the lower rear but you are a long way from Kansas City
Maybe I coud send some smaller pieces. ?


I made a 70 fender out of a 71/72 one time by grafting on the front lower section with the marker lights and butchering out behind the headlight bucket area (looked pretty bad but couldn't be seen when the fender extension was installed)

let me know if you still need the fender im right here in new jersey

the elky and chevelle have different profiles even up on the very front. thats why they use different headlight bezels.

Storm,

Please Email me at tomsarno@aol.com. I need to ask you a question.

Tom