Does anybody know where you can get a template for the holes to be drilled in the rear quarters for the SS emblems on a 66 chevelle? I also need the hole placement for the rear "CHEVELLE" and SS396 emblems below the deck lid.

There are alot of sites that have links to do that you just have to look for them. I am in the same boat with my 64. I am going to replace some of my trim, but those are going to be the main ones. graemlins/beers.gif

Just curious... did you put all new quarters on your car and rear panel also?? Why aren't your holes there?

MC

because i am building an ss clone and had the original malibu emblem holes welded up along with the rear bowtie holes where the chevelle emblems go.

My parts came without hole, but then again I didn't buy them, my father-in-law bought then a few years ago, and I am now putting them on for him, per say. The car is going to me, but thats something else. I think that you can buy them with or without holes, but I'm not fore sure. graemlins/beers.gif

Could somebody who has a 1966 chevelle ss measure how far the emblems are from body lines etc. I need the rear super sport emblem measurements and the rear chevelle emblem.