Hi Guys:

The previous owner had my car painted, and the taillight housing were on the car when painted. I think the gasket is in there (not sure). What are options here so as to not screw things up terribly? Razor blade the paint? I need to remove the housings to replace the tailight. TIA

------------------
Ron Cook TC Gold Member #1276
1969 300 Deluxe HTSS396 69 300 Deluxe (http://www.chevelles.com/showroom/bow_tied2.jpg) 325HP L35 (http://www.chevelles.com/showroom/bow_tied3.jpg) 69memorylane (http://www.chevelles.com/showroom/bow_tied.jpg) 1971 Malibu 2DR HT
"Never let fear and good judgement hold you back!"

You can cut it with a blade, It's ok to do that..

Thanks Brendan - is there anything I can do to prevent the aint from chipping/flaking?
R

You can wet sand down the rasor cut edge with 1200 wet paper to smooth it out and install new gaskets. Make sure you run masking tape next to the edge so you don't sand the corner, then buff lightly. Stick the tape on your shirt first,before appling to car, this will help to prevent it from puling to hard on the paint when you remove it.

What would I do without this site??? Do it wrong I guess http://www.chevelles.com/forum/rolleyes.gif
Thanks again!!!! http://www.chevelles.com/forum/cool.gif
Ron