Door/Qtr glass not aligning worth a lick after paint job and new rear quarters, that included resetting doors. MartinSR advice was VERY helpful on alignment of hood, etc. Didn't know if same type of time saving advice was available for what bolt adjusts what on door and rear quarter glass. Rear quarter/Passenger side is especially whacked in that it is "rolling INTO the car" too much, making NO contact with door glass.

Any advice? Thanks,

(p.s. If this is a repost, I apologize. I tried to post earlier, but don't see it anywhere. Maybe I put in wrong category....)

Fisher Body Manual has it all.

DN is right, it is all there. Of course it is in confusing language, but it is there.

Flye, Those quarters are tough but you can fix it. The mounting screws/studs that poke though the inside panel have slotted heads on them for adjustment. When I remove the window tracks I make sure not to upset/change their position. Sounds like yours were moved/screwed in or out. You can look at them and try and determine where they were originaly and move them back or start adjusting till you get the results your looking for. Infinately adjustable, only right in one spot.
Roger