Spray gun input [Archive] - Chevelle Tech

: Spray gun input


70 Elco Joe
Apr 26th, 04, 10:53 AM
Hi guys,

I was looking for a low CFM consumption paint gun to add to my stable. I have had good luck with my old Ebay $20 High pressure gun but the overspray is killing me. I was reading some posts where the Sharpe Platinum was recommended. I found this set of gravity feed guns on Ebay and was wondering if anyone has ever seen them or bought some.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=43987&item=2475626157&rd=1

I dont really want to shell out $250 for a Sharpe but if I have to I will. This set seemed nice since it has a low CFM usage rating and a primer and paint gun in one set.

70 Elco Joe
Apr 26th, 04, 8:52 PM
Ok evidently everyone was too nice to say bad things about the cheap gun :D Has anyone used a Porter Cable spray gun before? I saw this one and wondered about it.

http://www.toolking.com/portercable/view.asp?id=919

Its in the right CFM range for my 6hp 30gal compressor. Input anyone?