Has anybody ever cut-out the "divider" in a Edelbrock RPM Performer manfold??
I wonder if the mod would come close to a Victor Jr.?
Phil

Sorry about the double post.
------------------
Pat Kelley
66 & 67 El Caminos

[This message has been edited by Pat Kelley (edited 07-04-99).]

I wouldn't think so but it would give you a larger plenum. I think the Victor JR. is more of a high rise than the RPM, plus you wouldn't have the direct shot to the ports the Victor has. I expect it might raise the RPM capabilities of the manifold by a couple hundred RPM. On the other hand, it could very well cost a lot at the bottom end. If you try it, post your results. I'd be interested in hearing how it worked.


------------------
Pat Kelley
66 & 67 El Caminos

[This message has been edited by Pat Kelley (edited 07-04-99).]

Pat,
Yeah.... You do have a straight shot into the ports, I remember looking down one.

SO much for my ideas! Phil