Hello out there ! Has anyone purchased and installed a reproduced tailpanel for a 67 chevelle? If so how was the fit and where did you purchase it ? Goodmark has no idea when there tooling will be ready , they just told me to keep checking through the upcoming year, Thanks Frank

I didn't have to replace mine. Did you check with Year One pn RF29 $159.00
www.yearone.com (http://www.yearone.com)

Dave in Denver

Thanks , I'm Looking for someone who has purchased a panel from one of the vendor magazines and installed one and had any fit issues

I had the tail panel replace don my '66. I bought it from NPD. The fit was real good, but it had to be "finessed" where the tailight extension
met the panel on th einboard edge. Fit to the quarter panel real good. Not a bad fit overall considering the alternatives.

Good Luck

Mike

Still looking for someone thats used a "1967" reproduced tailpanel..... Thanks for your response Mike .......Frank in Mass.

I purchased a 67 tail panel from our sponsor, Ground Up. The fit is not too bad.

Thankyou for your reply Fred.....Frank in Mass.

ttt...Thanks

Hi, I replaced my 67 tailpanel with a new tailpanel that I purchased from Ground Up , since I replaced both rear quarters,outer wheelhouses,and trunk drop offs the fit was very nice , but the trunk lock location is about 1/8" higher than the original , which causes the trunk key to rub lightly against the horizontal chrome molding while unlocking the trunk. Good Luck

ttt