Was a pain in the Rear. I didn't get to the drivers side, any suggestions on how to make it easier, before I lose my mind and bend it.

You taking it off,or putting it on?

Taking it off--use the bottle opener end of a double "church key". Wrap it with a layer of duct tape to prevent scratches. Start lifting the molding from the bottom at either end. Progress to the other end.

Putting it on--slip the molding over the top of the rail first, then gently, preferrable with a rubber hammer, tap the bottom of the molding into place starting at one end and progress to the other end.

Mi dos centavos, but no charge to you.

Ditto to vettefella, graemlins/beers.gif

graemlins/waving.gif
Rick

Thanks fellas, and I'm putting it on.... :D

I like to tap it off from the inside with a block of wood. When you put it back on rub a little white grease on the drip rail. Also, try to keep your paint build up to a minimum on the gutter.