hello all!

I am replacing my turn signal switch in the column of my 68 Chevelle and was wondering if a blow up diagram exisit for for this procedure!
Thanks in advance!!

Tom

I replaced several items in the column of an '85 CJ7 I was rebuilding and the turn signal switch was one of them. It's not difficult with only three screws holding it in. The hardest part was depressing the inner lock plate down into the column housing enough to get the retaining ring out of the groove that holds it onto the steering shaft (core). Of course the steering wheel comes off and you may see a cover plate that can be pried off with a screw driver then you'll see the lock plate. My effort and my money now go into a 69' Chevelle.

I think I see how it goes back together but I have found 3 half inch springs in the column and am not sure where they go.

Thanks to a fellow member, JimL82, for helping me out!
Here is the link he sent me with the exploded diagram.

http://jimshea.corvettefaq.com/wp-content/uploads/2006/01/67-68A&FStdColumnD&R1-31JA06.doc