|
SebJr Feb 24th, 06, 9:29 PM I pulled my exhaust manifolds off today which I'm pretty sure are the original set, where the part #'s and date codes are look like one big burr. I took a wire wheel to them just to see if I could make out the #'s and no luck, they are pretty rough, will a blasting revive them? EddieC67ss Feb 24th, 06, 10:50 PM If they are that bad, not likely. SebJr Feb 25th, 06, 11:02 AM If they are that bad, not likely. Are the new ones available Identical, other than date codes? Quality wise are they same as OEM? I was planning on having my originals powdercoated but if none of the #'s are ledgible is it worth it? Would I be better off getting a new set ? Any opinions or advise is greatly appreciated. thanks Seb SebJr Feb 26th, 06, 10:59 AM Drivers side is crystal clear K 18 5 , why would one side be so unreadable and the other plain as day ??? Would a replacement have some markings on the engine side of the manifold? If so maybe I'm tring to clean up and read something that isn't a distinct code ? Any thoughts?? | ||