|
dshvrs May 16th, 01, 7:54 PM Anyone had problems with reproduction wheel well mouldings for a 69 chevelle. the ones i got from NPD don't fit at all. they are off on one side by .5 to .75". should i try GM moulding or did my body man mess up something in the quarters? thanks in advance for your help... von May 17th, 01, 2:48 AM Sounds normal for repro ww moldings. The ones I got for my '69 were absolute crap. I think they're all made by the same mfr., C____x. At least one of the GM moldings is no longer available. ------------------ von '69 300 Dlx SS TC #15 ACES #1575 My '69 SS (http://sites.netscape.net/von69ss/homepage) Dan Orgill May 17th, 01, 12:39 PM Yuppers, they are crap. ------------------ Dan Orgill TC May 17th, 01, 3:18 PM The same thing happened to me a year agao. I was very disapointed and the vendor would do nothing other than tell me to call the manufacturer. I reciently ask a sales person at Classic Muscle about this and the Goodmark trim. I ask if the Goodmark openings would fit the rear skins I just bought, he assures me they would fit with NO problem and they should also fit the OEM fenders. Is he telling me a falsehood???? T.C. dshvrs May 17th, 01, 7:39 PM thanks for the responses. now i know i'm not crazy. i get the feeling that i'm going to run into this alot with all the damm repro trim and bolt on stuff i bought. Any other repro stuff i should shy away from? I'd rather find out now then after drilling a few holes. Anyone know where you can get a new complete set of original wheel moldings. Most of my books have them listed, but seems to me that one of them is hard to find... thanks again. | ||