I just put in my muncie today but had a problem with the length of the stock clutch fork rod that came with the kit from OPG (complete clutch pedal and rod kit), it was about 1" short, I should say that it fit the stock bellhousing that came with the trans but I opted for a lakewood bellhousing/ heavy duty fork/adjustable pivot ball so maybe that was the problem. I ended up buying a clutch fork rod for another type of car but had the length i needed, so i just ended up cutting it to length and rounding out the ends and now it's good to go. Just was wondering if anyone else had this problem? Plus the clutch rod that goes from the pedal to the z-bar would'nt fit in the pedal hole, had to drill it out to fit, is this normal?