Anyone use either the 3 piece or 1 piece trunk pan? I'm geeting ready to have it done by a local vody shop, just wondering which is best. The 3 piece appears easier to work with, I'm just looking for suggestions.


Thanks,



------------------
JR TC #1098
My 69 Convertible (http://www.erols.com/ruther/69conv)

My 2001 Z28 (http://www.erols.com/ruther/z28_5.jpg)

Definitely go with the 3 piece.
-----------
Brett
'67
SS396
clone

The one piece doesn't fit in the trunk lid opening. So you'll have to bring it up from below.
Use the three piece.

I used the 3 piece, not terribly impressed with it.. If I had too do it all over again I would have used the 1 piece. however one of the 1/4 panels would have too come off if you didn't somehow split the panel. As was stated before the one piece won't fit in the trunk opening.

------------------
X-Ray View of my Chevelle :D (http://www.normieschevelle.com/sideview.jpg)
Getting Closer (http://www.normieschevelle.com/passfull.jpg)

I used the two piece trunk panels from NPD and was very impressed with the fit and quality of the parts. They also covered more of the trunk area then the three piece. All the three piece floors I have seen stop right before it goes back vertical, but the two piece went past the area directly above the shocks.

[This message has been edited by sevt_chevelle (edited 11-13-2001).]

I used the 3 piece from OPG. Pics of the install on my website.

------------------
http://webpages.charter.net/65chevelle/