drums&cars
Jan 22nd, 02, 9:23 PM
For some reason, my rear window moulding will not pop back in place. Ive tried and tried for about a month, and it wont stay. It seems like when I push down on the moulding, the clip gets in the way some how, but when I pull the clip back a little bit, It just wont catch. This is super frustrating http://www.chevelles.com/forum/mad.gif!! I bought the clip clips from OPGi, if that means anything. Is there some special way to do it, or is it something little that I forgot or screwed up(knowing me, that's very likely http://www.chevelles.com/forum/redface.gif). Any help is good help.
------------------
Trevor
1968 Chevelle Malibu
dabuickman
Jan 22nd, 02, 9:47 PM
easiest fix, drive to a glass shop and give the guy a $5 bill.its probably cause the clip is too tight to the body and needs to be pulled away to let the moulding down far enough....if they were old clips then it would the opposite. you could do it yourself if you had the too but you have to be very careful. rob
drums&cars
Jan 22nd, 02, 9:57 PM
Alright, thanks. That sounds like a good idea
------------------
Trevor
1968 Chevelle Malibu
350/th350, 3.73 peg-leg 10 bolt
1969sleeper
Jan 23rd, 02, 10:05 AM
drums&cars,
The rear backlite molding clips from OPG do not work correctly. I had the same issue you are having. I ended up going to NPD with the old clips and matching them from their inventory.
Good Luck,
Bill
dabuickman
Jan 23rd, 02, 10:55 AM
gotta love the aftermarket....everything fits soooo nice.
drums&cars
Jan 23rd, 02, 1:24 PM
The OPGi clips are junk? I knew something was up with them. How much were the NPG clips?
------------------
Trevor
1968 Chevelle Malibu
350/th350, 3.73 peg-leg 10 bolt