Can somebody tell me how this clutch fork pivot ball is supposed to be set? I tried finding instructions from lakewood-no luck.

Can somebody tell me how this clutch fork pivot ball is supposed to be set? I tried finding instructions from lakewood-no luck.

The pivot ball height depends on your flywheel thickness. What is your thickness from the disc surface to the crankshaft flange? Measuring from the outer edge of the flywheel is not the correct thickness used. We always place the flywheel disc side down and measure through a crankshaft mounting bolt hole for the proper thickness.

Regards, Jody

kballs-

I have scanned and added the Centerforce instruction sheet for the adjustable pivot ball HERE (http://www.71protouringchevelle.com/Clutch%20Instructions.jpg). Good Luck!

For what length TO bearing is the 4.75" reference used?

For what length TO bearing is the 4.75" reference used?

The short one.

Regards, Jody

The short one.

Regards, Jody


1.380" ??