finally got the 396 dropped without the exaust manifolds now we cant seem to get them to go in im sendin a link to the ones i purchased. do you have to remove the steering column to get them in we are frustrated and finished for the nite thanks for all the help

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1,1&item=4578169477&sspagename=STRK%3AMEWN%3AIT

That's because the are for a full size Chevrolet, will not work on a Chevelle. I see so many ebay auctions that list these type manifolds for a Chevelle. Get your money back.

does anyone have the correct casting for 67 exaust manifolds i know or where maybe i can get a good set thanks

3892307, 3909880 are two used in 67. If you aren't worried about originality they make pretty good repo's

I had the same problem with mine,, I bought a set at Carisle that was suppose to fit...Wrong I searched evilbay for weeks ended up buying a repo set from Ground Up...... fit and appreance... A+ (for repops) imo..:)

The only problem with the repos the pass side is for later built 67's and up.

but the repo passanger side will still fit correct thanks

Yes it will.

still debating what about headers im sure there are some that will work any info on a good set thanks

Here we go again "Fits Chevelle" Numbers look familiar.

http://cgi.ebay.com/ebaymotors/1966-67-Chevelle-Exhaust-Manifolds_W0QQitemZ4586657456QQcategoryZ42606QQrdZ 1QQcmdZViewItem

Dynomax Ceramic coated is a reasonably priced set of full headers. There are also headers that resemble the old "rams horn" manifolds that feed a 2 inch down pipe.

Anyone else?

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=4578169477&category=34203