* Anyone know a supplier that offers the "lock linkage support clips" that go inside each of the doors...2 per door, white plastic pieces I believe?

* Rear edge of hood molding for SS/cowl induction - I always get nervous with pieces that are offered by some suppliers and not others. Anyone have experience with supplier that offered a good fit with this piece?

Thanks.

Ohhawk, I believe that Year One sells those clips not for sure but I think I remember seeing them in there. If they dont have let me know as I have a extra set of doors and you can have the clips. I will be at the swap meet in Des Moines on May 3 which would be saturday

And on the hood molding you might want to check with the GM dealer there in Des Moines as I think you can still get them, if not give Rydell Chevrolet in ceder falls a call, they will treat you right, just tell them Larry's Auto from clarion sent you. Ask for DJ...Eric

------------------
1970 chevelle
1970 chevelle SS455 not a typo its a buick baby
1949 and 1972 chevy trucks
http://briefcase.yahoo.com/bc/sevt_chevelles

Ohhawk, I baught a Cowl hood from goodmark, and their chrome rear trim and, it didn`t fit for ***t. My body man spent several hours on it to get it to look halfway decent, and it still has a space between it and the hood on the lower edge of the cowl. Go G.M. on anything you can, espically if it will be seen, when the car is done. Also the hood had several little dings and low spots that had to be worked out before paint.