I need some advice on the best way to remove surface rust up inside the sail panel/b piller area and inside surfaces of siffening supports for roof and under panel between back glass and all other pain in the neck places that my 65 has surface rust on. I can't get sander/wirebrush in there, so I need alternatives before I treat with POR 15 or like products. I have body on rotesserie so I don't have to work overhead. Has anyone used sandblasting, glassbeading, or other options in this area? Where did you get your equipment? What are your opinions on brands, quality and price. Thanks

[This message has been edited by jon65 (edited 01-03-2003).]

[This message has been edited by jon65 (edited 01-03-2003).]

You can blast with sand or glass. Harbor Freight and Sears both have small blasters if you have enough air to run them. Keep in mind, not pressure, but volume is the key. If you use sand, make sure that it is dry.


------------------
Dennymac
'69 Elky Rebuild in process
dennymac.com (http://dennymac.com)