- Cheaper 3000+ stall converter for 200-4R????
- New Process 3-Speed Manual w/OD?
- What trans good for ~550 hp/tq
- Adjusting the Kickdown cable on a TH350??
- Suppliers for performance overdrive transmissions
- 200/700 Swap Tips, With Part Numbers
- 4L80E?
- clutch fork free play
- Fact or Fiction: resting on the shifter in 4th is bad.
- TH350 Gear Indicator Problem
- Throw out bearing noise????
- Need some gear help.. GM 3.40's?
- axle play
- tranny how to swap a auto to a man
- Muncie - Problems going into 4th
- speedo calibration help. can you tell me what gear I need?
- '74 TH350 Shift Kit
- Muncie Input shaft
- Rear end with m-20
- Richmond 4+1- How is it working out
- 2.73 - 3.08 Limited slip difference?
- what is the biggest feature between 12 bolt and 10 bolt
- Another VIN question
- kickdown (detent) adjustment thm-350
- Bellhousing for what vehicle?
- cooler lines
- TH350 Drain?
- Differential interchange
- Saginaw transmission ID
- Clutch adjustment
- Turbo 400 in a 64 Chevelle
- clutch / flywheel recommendations?
- Short or Long Throw out bearing?
- LOOSE SLIP YOKE?
- Rear end gear ratio
- manually shiftingTH-400
- Used tranny- been sitting a year, any probs?
- calling biggearhead
- 67 console auto trans shifter
- Flywheel size ??
- Need to know if I have the 8.2 or 8.5
- 12-bolt conversion
- Lowest Price on a rebuilt 5 speed tranny
- Bucking (best word to use)
- please help me understanding driveline angle
- Lakewood Scattershield
- 1970 SS 4-Speed???
- Wrong kickdown cable?
- Speedo gears
- 10 bolt vs 12 bolt posi units price - need more info
- Difference between 4 speed and automatic
- torque converters
- 88 Firebird rearend in a 67??
- 70 10 & 12 bolt posi and 66 elcamino
- Set up when changing differential, but not gear set
- Synchro rings sticking......
- tranny fluid leak..
- Shifting Problems
- Tranny Cooler / Aluminum Radiator
- 350 Transmission overhaul and install price ?
- TH400 downshifting problem (67 SS396 Chevelle)
- Code??
- Stall converters & coolant temp/mpg
- PLEASE help! I need some assistance on turbo 350 linkage
- I Found A Cheap Converter
- b&m transkit instructions and other rebuild q's
- Using drag race axles on the street
- Z-Bar (bellcrank) question
- Will My TH350 Live Behind a 600HP/550TQ 454?
- Will a 12-bolt carrier fit in an axle with a 10 bolt cover?
- Richmond rear gears... noisy?
- which auto tranny is more complicated to rebuild?
- changing to a 6spd. tranny...
- Best place to buy 454 flywheel ??
- Help with Muncie/Hurst fit in 68Chevelle
- shift points
- axle seals
- Convertor Recommendations for 67 Chevelle
- Ring and pinion swap 12 bolt posi
- Regearing a TH350
- Living with the 200-4R
- Correct Converter ? Repeat question
- 10-bolt limitations
- first time rebuilding tranny
- Rear end noise
- Rear end align
- Clutch problems - HELP!
- '68 12 bolt driveshaft straps ?
- Opinions on TH400 Pressure Test Results...Strange
- Gears Too Short
- 350 Trans Detenting
- Drive shaft
- turbo 350 cooling lines
- 200r4 rebuild questions
- Odd rear end stamping 'CHC' ?
- TRANS KICK DOWN SWITCH
- How much $$ for 65 12 bolt
- pinion nut
- Need help 8.5 rear end
- another 10 bolt question.
- If it ain't broke don't fix it?
- 400 TH probs.
- tore apart my 4+1 nash
- speedometer error
- Removing and replacing rear-end - pinion angle
- Changing Ring & Pinion Gears-Carrier Questions
- changing from a 350 to a 700R4...please help
- 700R4 INTO 71 CAMINO
- how strong is a stock 12 bolt
- Can I use a olds 12 bolt rear in my 67 chevelle
- Donor Car Transmission
- slipping th400
- T400 torque converters
- Technical Referance?
- TH-350 leaking in neutral
- will my 8.2'' handle some power
- Will it last?
- TH-400 Q's
- Gear Ratio
- Will this converter work?
- rear end decoding
- ford 9 inch
- Wally you have mail :o)
- 3-Speed standard question
- 2004r
- stick surgery?
- trany or converter
- manual decision
- whats the problem?
- SLIM JIM
- Does Anyone Make 3.55 Gears
- Trans. I.D. ?
- how much power can a 10 bolt handle?
- Some Saginaw help needed!
- How Tough is My 12 Bolt
- I'm Looking for Big Gear Head....
- gears
- How do you change back after full manual ?
- Clutch kit for 68 8.2 10 bollt
- tranny rebuild kits
- 8.2 Differential interchangability.
- I give up - I need help th400 shows no pressure
- I think my rear is toast...
- Hey BigGearHead, will a dana 60 fit on my 71 chevelle BB???.
- Shelf life/th400?
- TH400, stuck in low
- th350 in Olds?
- 2 speed powerglide inspection?
- 2004r conversion
- Is this a 3.08 rearend "CA0304W" off of the protect-o-plate?
- Stall converter 101? What exaclty is a Flash point?
- Auto to Richmond 5spd Swap
- Double check me guys....10 bolt posi
- Are 3.73's too high for the highway?
- length TH400>700R4
- Will a 12-bolt posi from a 68 chevelle fit on my 71 chevelle????
- What gear ratio should i go with?
- Trans cooler lines
- muncie m20 install
- new tranny...new problems
- Changing carriers
- Needed: Transmission Repair in NW NJ
- Need help in tag team
- 4.56 gears
- Just bought a 12 bolt posi rear & I have a ?
- Information needed 700R4 Transmission
- 4.88 gears... Yes or NO!
- Why won't my powerglide shift into 1st gear?
- 70/66 rearend
- Broken ears on Muncie transmissions.
- Opinion on 3.73 gears
- Shifter for 700R4
- BOP 10 bolt noise, what could it be?
- crossmembers
- Big Mistake Made,Advice Needed
- Posi fluid?
- trannie kit
- trannie kit
- leaky BW Super T-10 suggestions
- Rear end swap
- Rear end swap
- Rear End Fill Plug
- Flywheel Questions
- transmission swap
- Will it fit?
- Pulling 700 R4
- head is spinning..lockup-nonlockup
- 700-r4 not locking
- What is stall on stock convertors
- Changing gears
- 12 Bolt Options
- posi ugrade in Ma?
- Adjustable Vacuum Modulator
- What Price To Expect For a Used Overdrive
- powerglide work for a 396
- Installing a new rear end advice?
- Trans Cable Extension
- Where to buy Eaton Posi?
- WILL THIS FIT - TH-350 to 1985 700R4 / in 1971 396
- Clutch ball in block - special tool to tighten?
- What should I expect to pay for a Muncie 4 speed rebuilder (core)
- Transbrake installation
- 3 speed auto with shift kit
- Help: Leaking 700R4
- Biggearhead can you help please?
- 454flywheel
- th350 LEAK
- '71 TH350 Column Shift Linkage
- rear identification
- st10 id
- Posi disassembly HELP on a '94 Z28 rear.
- Clutch Linkage Problem
- Ford nine inch in a Chevelle.
- I'm confused: Earls AN fittings to hose to hard lines
- rebuilt TH-350
- Rear gear swapping
- New gears, new synchros...hard to shift!!!
- Transmission
- Gear ratio ?
- bell housing
- Flywheel numbers for 396 11" clutch
- Driveshaft length.
- torque converter mistake
- Clutch chatter
- Muncie Identification help....
- Trans shop Referial
- Ranking Rears
- rear identification
- 66 console/shift linkage
- P8R27 muncie I.D. (casting 3925660)
- Slight movement in the rearend, stange!
- 700R4 TV bracket
- Economical 12 bolt?
- M-20
- Turbo 350, is this a "on the car" repair?
- 12 bolt swaps
- Thanks
- 1969 chevelle transmission lever ?
- M 22 Super T 10 difference
- driveshaft /yoke question!
- Is this diff out of a monte? reads TLE on the tube!
- Torque converter recommendations?
- Differential Leak
- Any Luck so far BigGearHead?
- Proper washers for Zbar, clutch cross bar
- 66 factory shifter
- 6speed
- Ring gear fit on carrier? Please help!
- shifting troubles
- pg vs 350 tranny