- M21 Leaks
- Another gears question?
- Why are Auburn Diffs so bad?
- tranny rebuild?
- 1967 crossmember
- what is the 12 bolt rear i hav out of
- Yoke?
- Differential Lube Question
- M20 vs. M21
- New Drive shaft/Old Transmission
- Diferential whine
- What Trans to Use
- T400 with Gearvenders overdrive
- TH400 Lines Installation '69
- What tranny to use?
- 67 steering box replacement
- 12 bolt lockers?
- Th-350c
- Shifter Question
- Loud clicking sound when letting out the clutch
- Local Tranny & Rear End Shops??So Cal
- Recommendations for shipping transmission ...
- Best Clutch and PP?
- TH350 Rebuild ?
- 700R4 - www.maddogtransmissions.com
- temp sensor location?
- rebuilt 12 bolt
- dumb question of the day....
- 700R4 Question
- new floor shifter
- 4 speed bellhousing question SB
- Kick down switch for the 400 transmission
- Trans cooler line brackets
- 7/8" countergear muncie - what are the limits?
- slipsliding
- Kickdown Cable for 350
- Best rear posi unit
- Need 1971 10 bolt axle breakdown
- Need pictures of 700R4 TV cable setup for Holley
- Flexplate replacement on 65 SS auto
- New Detroit for 12 bolt
- Flexplate question
- 12 bolt series 3 series 4
- Muncie Info
- 10 bolt ID
- aluminum driveshaft?
- Need speedometer housing for my richmond 4+1
- INSTALLING lokar dipstick? th400
- Good aftermarket or newer interchangeable power steering??
- 4 series carrier 3:73's
- Stall Converter Identity help
- CK Performance Tranny - Put this Tranny Shop on your list!
- Reverse Light Switch
- th400-350, lines to cooler ,what do u use?
- 1968 Chevelle 4 speed bellcrank support bracket
- Eaton Or Richmond?
- Muncie speedo gears 68 Chevelle SS
- 78 Malibu TH350 shift point problem
- What was the stock gear ration on 67 w/ 283 and PG
- Differential Rebuild Video
- cross member
- z-bar spring with headers
- Chevelle Rear?
- 67 clutch pedal to 71?
- C-Clip problem.
- Backlash?
- Bell Housing
- 350 Turbo Leaking at the linkage.
- is shifter hump necessary with bench seat?
- got have a manual
- got to have a manual
- 8.2 posi
- M22 first gear
- Auto To 4 Speed Conversion.
- Centerforce Clutch
- BGH , help please
- Transman another converter ID
- hydraulic clutch
- Beadblast trans case?
- fair price?
- '71 Chevelle station wagon donar
- '71 Chevelle station wagon donar
- tremecs
- rear end compatability
- Is this possible? Clutch pedal problems
- BGH/power trax
- Tremac tko
- How much tranny fluid??
- Muncie Super Case Questions
- Rear end gear selection
- Best diff. for late model El Camino?
- Strange converter/ transmission question
- Where do I get drive gear and driven gear for speedometer
- Super T-10 info needed
- GM 12 bolt v.s Ford 9 inch
- 12 bolt diff. rebuilder in New Jersey
- Replacement trans for Muncies
- Cable for AutoMeter speedo
- Ball park to offer for manual trans drive train set up
- Transmision tag
- Th 350 strenght
- tranny ,bell housing decode
- Question about Dual feeding TH400
- 1965 Best way to determine where to drill the hole for the Clutch Rod.
- 12 bolt yoke
- Identify M20/M21???
- Hurst Super Shifter for Muncie.
- Which 12 Bolt yoke is better?
- Clutch won't adjust enough. Help!
- Awd?
- 4 Speed Conversion Information
- TH350 dosen't kick down or downshift
- What casting numbers???
- Ring and pinion identification question
- Junkyard Driveshaft Recommendations ?
- Tranny Suggestions.... Automatic...
- Th400 wierd shifting
- Best Place for Trans Cooler
- Fairbanks Shift kit
- Question about a TH 350 Trans
- Manual Shift Body?
- TH400 fluid level question
- 68 muncie speedo gears
- Blowproof housings and block plates
- M21 behind 454
- Transmission no work
- 4 speed shifter
- clutch linkage
- Sheared off the pinion
- TH350 vs TH400
- neutral balance flywheel
- How can you tell the difference TH250?
- L480e conversion from 4WD to 2WD.
- Spash Shield for 68 powerglide transmission linkage
- Moroso Brute Strength Posi Diff for street
- tranny rebuild or what????
- posi
- Which type Ford 9" rearend axle bearing best, small big or torino?
- foot pedal bushings
- Vibration, I may have made a breakthrough
- Clutch Help on 72 w muncie 4 sp
- vacuum for 350 tranny
- Can someone look up a part# please.
- Flywheel question?
- Tremec TKO 500 with an LS2? Please Help
- u-joints
- 4l80e queston
- Daiken flywheels?
- TH400 Not Shifting Right
- Rebuilding a 4l80e ...
- Horseshoe shifter install problem
- Muncie experts please help.
- Aluminum driveshaft
- What's the difference??????
- Rear end question
- Which ford 9" should I look for?
- Stock Rar End Question.
- Caps for Driveshaft
- 200 4R/700 R4 question
- Yoohoo...I might have found a posi
- Gear Vendors OD
- Check pics: who sells these rings??
- Engine removed, can't get transmission into neutral.
- 4L60E & Dexron VI
- 3:90 Richmond gears in 12 bolt posi?
- tranny ID
- What is the going rate for a 200r4?
- Moser c clip brearings very tight
- Question on 700r4
- HELP Decode Muncie 4 speed
- TH400 cooler line question
- 5 speed for a 66
- Stock diff started leaking
- Welding on axle tubes
- TH400 downshifts too quick..
- 10 Bolt to 12 Bolt swap - Installation complete
- Tranny I.d.
- long yoke for th400 need help
- Help Help Turbo 350 ? Im Puzzeld
- rear end axles
- Speedometer Cable Extension
- Flushing a converter
- Ring & Pinion Setup - GM 10-Bolt - Help!!
- Mom's 96 Cougar stutters when shifting
- No Thanksgiving-slipping???700R4
- bellhousing
- saginaw questions
- trans shoping
- 8.5 for a 69 el camino
- tranny help
- Muncie Install Some quiestions
- aftermarket shifter in stock center console
- hurst shifter comp plus - ID this #?
- Jegs T10?
- Rear-end Code???????
- How much can a shift cable bend
- Building a powerglide
- Muncie
- Th350 speedo gear
- looking for a junkyard 5 speed od
- Viper T-56 swap
- Cross Member
- Is my transmission dead?
- speedometer
- transmission rookie HELP
- Just finished my muncie swap, and the car has no power.
- torque converter
- Fluid capacity TH350
- Saginaw Part
- muncie speedo drive gear
- T56 from an 05 CTS-V???
- Muncie 5-spd - Update?
- Anyone in the MD, DE area?
- Gear swap question...
- Gear swap question...
- Clutch adjustment problems
- turbo 375 ?
- m20 first gear ratio
- 12 bolt spring perches
- Torque Arm for our rear ends ?
- th400 blowing oil
- What brand???
- TH400 rear seal and bushing blew out
- Th 350
- kickdown cable problems
- will this work????
- gear ratio question
- HP loss 2004r,4l80e and info in general...
- 66 chevelle rear gears to low
- clutch linkage and headers info.
- ITS A TH400 AND NOT A TH350,and why is it shifting on its own
- Mikronite treatment for ring & pinion?
- TH350 Kickdown Cable
- need help with TH400 parts search
- 2.56 posi in 64 chevelle, is it possible?
- need a little help with axle codes !!
- Posi unit rebuild
- gonna rebuild my 700r4 any advice?
- 400 trans, wierd prob?
- driveshaft length, am I missing anything else?
- Rear end ?
- need help figuring rear end
- Non posi rear end convert to posi or buy used posi
- Pontiac T-400
- Transmission weights
- 12 bolt
- Swapping trans
- U-Joint
- 10 Bolt Posi Install
- Ring & Pinion Tooth Contact Pattern