- Worth keeping?
- 10 Bolt 8.2 or 8.5?
- flywheel question
- New shifter needed
- Automatic linkage question
- What do i Have
- 69ss clutch issues/lakewood
- 69SS lakewood/transmount/driveline issues and questions (long)
- Will a 70 Chevelle 12 bolt rear end fit in a 69?
- Tremec Console 66/67 Shifter options so far??
- Hurst shifter rebuild
- Transmission Swap
- Pinion Yoke
- 70 chevelle had floor shift, converting back to column....
- 12 Bolt 1350 Yoke
- transmission mount ?
- Positraction rebuilt kit??
- Calling BigGearHead
- 1970 Chevelle Z-Bar Bracket Location
- 700R-4 or 200R-4 in 66 chevelle?
- 700R4 or TH350 for this combo?
- Hard time bolting driveshaft to rear!
- Dowel pins for locating transmission
- Block Plate or Not???
- Hurst Shifter Install on 67 SS
- How to Flush the trans fluid
- Measuring driveshaft
- T-400 driveshaft?
- Can't Stop The Leaking.
- changing the pinion seal - 67 10 bolt
- Question for BGH
- T400 overdrive
- Carrier decoder
- Gear Oil Leak
- Detroit area Transmission shops
- Lock-Right install problem!
- ? on 69 m-22 muncie
- trans noise in some gears and not others?
- break in delima
- Muncie ID please
- Driveshaft too short...
- How do I identify a 66 10 bolt?
- 2004r offer good?
- switching to synthetic?
- 65 console / trans hump and Hurst shifter
- been asked a hundred times... (tranny swap question)
- When running a midplate....
- Jeep tow vehicle trans
- What is a Muncie parts transmission worth?
- M21 vs T400
- viper T56 trans swap
- 3840383 bellhousing.
- Limited Slip Differential
- th400 / 475 question
- electronic kickdown
- What parts do I need to make my stock Th350 race ready?
- What's involved with replacing speedo gear on ST-10?
- Shifter seal leak
- Urgent question?
- TH350 ,No third gear
- Leak at rear seal of M-20
- TCI Streetfighter with BB
- 12 bolt
- Attn Big Gear Head
- Preload springs in 12 bolt
- Superior Axle and Gear Evolution Series Axle Kits
- Original Shifter Help
- shimming transmission on 66 chevelle?
- centerforce street choice
- Lakewoods Bellhousings Price Jump???
- Shift Kit Question
- Hays Performance Clutch Kit Pressure Plate
- Planning a rear swap
- filling fluid on fresh 700R
- is this too much $$ for rear repair
- TKO in a 66
- How much oil? torque converter
- M-22 problem
- TSI torque converters
- Experiences with Truetrac ????
- rear seal I.D. to small for new 400 yoke
- REAR END GEARS
- tranny cooler installation
- TransGo: Reprogramming kit w/Shift Kit Together?
- Rear sway bar
- gear brands???????
- plate#
- Manual Valve Body?
- Spider gears
- th350 to 400 slip yoke
- My CF DF diaphragm and weights look of center?
- gear and truetrac installation
- What gear ratio?
- Alum. flywheel-pressure plate bolts+loctite?
- M22 Question...DZ or Wally...
- Which Clutch to Buy
- powerglide or Th-350
- tips for making 3-4 clutch last on 700r4
- 12 Bolt Applications
- Hewland or Richmond?
- code on 72 SS 10 Bolt
- New Flywheel Required?
- 700r4 shift questions again?
- Muncie M20 questions -- Wally or someone else?
- Bellhousings
- Need Advice ....posi or locker for tow vehicle?
- I Striped It! Help
- Help with these numbers?
- Govlock rear
- GM gear Manufactor
- cooling ling Q
- bellhousing
- Gear Ratio
- Help with gear change wanted.
- What torque converter to use?
- Speedo gear color swap
- 3:31's vs. 3:42's
- clutch automatic
- How to replace speedo drive gear on ST-10
- auto to 6 speed?
- which clutch
- Speedometer not accurate
- 700R4
- Oil change and gear ratio on a 9" rear
- Getting muncie rebuilt in Minnesota
- 66 shifter up grade but keep original handle
- Good prices on custom length axles? Big Gearhead?
- Easy linkage question
- Jerico,G-force or Muncie
- Vent tube on TH350
- th 350 problem
- TransGo or B&M Shift Kit for TH400 ?
- 9" ford rear end complete housing
- Paging Big Gear Head
- Left Turn Spins Trans!
- Calling ...TJ1967SS Re: 67' 12 bolt
- 8.2 gears
- What rearend/gears should i run?
- turbo 350
- Muncie Speedo promblem
- Muncie 20/21/22?
- Hurst Shifter
- Lowest (highest #) available gear in 8.2 10bolt?
- 70 Trans Conversion?
- M20 -- keep it or dump it?
- adjustable pivot ball question
- A Big Thanks To Wally!!!!
- Vacuum test - what should the pressure readings be?
- loud chatter
- what gears do i need????
- PG to TH swap hints and question...
- 4 speed trans hump console 1969
- Hurst Shifter Question
- HEY, WALLY!!!!!!!!!!!!!!!
- Muncie M-22 roller 1st question....
- I need help
- what else do I need for a 6 spd conversion
- Can i use auto crossmember with m-20
- auto to man. coversion
- Moser rear end swap... new driveshaft?
- single track gears into posi rear end?
- TH-400 parking pawl oddity
- 700r4 tranny
- TH350C... anyone using one?
- TH700 R4 to LOCK or NONE- LOCK
- Little brass tag on Muncie side cover
- hard to get into gear
- Need Super T-10 Repaired/Rebuilt
- Posi Springs
- TH400 to M21
- 12 bolt passenger dana 60 posi?
- Best Improvement
- Turbo 400
- Chevelle Driveshaft Cutting to fit Gear Vendor
- Gear Vendors Update
- tranny linkage
- M21 transmission bolts 65 malibu
- Hydraulic clutch setup question......
- Flywheel Dowel Pin?
- rear end housing codes??
- Muncie 4-speed rebuild kit
- need help with visual diff between a 8.2 & 8.5 rear
- Putting in a 700r4, need help from you guys.
- th350 problems
- Rearend Decode
- Torque Convert Bolt Size?
- buying a used Muncie M21
- looking for tranny cable bracket for 700r4
- ID 12 Bolt
- Looking for a 67 turbo 400 core
- Internal Lockup Question
- Lakewood scattershield ID help
- Tranny Gurus
- Driveshaft Length
- Crossmember Interchange
- Why didn't they just put a model number on it?
- SOOOO, I tore apart my 700R-4 and now need help.....
- 12 Bolt flange vs 10 Bolt flange
- Tremec TKO's in PA
- turbo 350 questions
- Son Put 200R In Park With The Wheels Moving, Now Doesn't Shift To 3rd, Update
- Backwards crossmember
- Is it possible?
- Suggestions: Fix/Rebuild T400, use old M21 or Buy 700R
- Anybody purchase driveshaft from "The Drive Shaft Shop?"
- 2004r Rebuild Questions
- What can hold up to it?
- Gear change on speedo
- speedo adapter for an M22
- nova bellhousing
- cluster for a st-10
- Shift Kit Questions
- 1970 Monte Carlo 12 bolt rear swapped with 1972 10 bolt rear?
- 3:73 or stay with 3:33's
- #'s on Borg Warner T-10
- Bell Housing
- Saginaw vss MuncieOD ratios
- M22 vs M22W Close or Wide? 4-speed Conversion
- GER transmissions
- think i've been had 68 rear end help
- What rear is this animal?
- ?? for Jake and 200r4 trans experts
- rear end decode
- Pump Bad? Options?
- Olds 12 "bolt"
- Help trans cooler direction ?
- clutch recomendation
- buying a used bellhousing
- SHIFTER LINKAGE BOLTS
- Anyone Know A Good Transmission Rebuilder In Portland Oregon
- Question for Big Gear Head
- Help, seal leak on a Th350 shift shaft.
- Clutch return spring
- Stuck in 2nd Gear
- 8.5 rearend ,2.73 carrier can be used with a 4.88 ring pinion ??
- difference between 10bolt & 12bolt
- torque converter clearance
- TH350 Rebuild??
- Trans torque ratings.
- 67TH400 TURBO-HYDRAMATIC
- rear end options
- bellhousing id
- Question for Dan72 and other 700R4 experts
- Rear End Lengths Any Vehicle....
- torque specs 7 5/8 10 bolt
- Driveshaft balancing
- muncie ?
- 71 cross member
- Manual Tranny?
- Don' talk to me about cost!!!