- Dismantling a Muncie
- What size are 12 bolt spider gear thrust washers?
- In dire need of info asap.....
- z bar/header issue
- Back from down under!!!
- GM 12 Bolt "C" clip wont' come out
- Bell housing ?
- Where's the date?!!!!!!!!!!!!!
- Speedo gear change - drain fluid first?
- quick help needed will it work? Posi rear end change
- S.S. Bolts on my Drivetrain?
- Converter problem 350/400 ?
- Trans temp ?
- 700r4 swap done
- Muncie M-20 or 21 What would be a fair price...
- 8 bolt rear end
- eng. swap
- Should I install a temp gauge for the tranny?
- "MUNCIE 5-SPEED"
- 12 bolt gasket
- Heli-coil
- Will a 12 bolt truck gear set fit a car?
- ratcheting horseshoe shifter
- Gear ?
- 57-64 Olds/Pontiac Posi info needed
- transmission vent?
- m-20 to a m-22
- 8.5 inch 10 bolt
- 12 bolt axle and c-clip question
- vette TH400 governor?
- 200-4r driveshaft bushing removal while in car.
- Car Eats Clutches
- Neutral safety linkage
- 3spd tranny decoded
- Bell housing I.D.
- 66 10 bolt to 12 bolt
- 10 bolt axle removal
- TH400 Bolt-on Yoke?
- TH 400 linkage cable
- governor-- diff RPMs in diff gears?
- axle ratio?
- Saginaw 4 Speed Transmission
- posi clutches??
- 65 PowerGlide, what to do?
- 700R4 or something else swap?
- Another 10 Bolt Question! Good enough For 600 Horse??
- ebay rear gear/posi packages question
- Anti-hop bars
- question on transmission coolant lines
- TH 350 kick down ain't kickin'
- 10 bolt 8.2 open diff axle gear thrust washer
- Dayco Parts --any good?
- M-20 or M-21 please help
- Saginaw in a Vette
- 2.73 Open to 3.36 Posi, what's involved?
- flywheel and bellhousing ?
- Transmission flush?
- smaller clutch disc
- TH400 Speedo housing seal
- Once Again. End all post on big clutch bellhousings..Car VS Truck
- Muncie shifter
- Tremec OD. Ratio
- 3.07 open 12 bolt hmmmm....
- trany identification
- Flexplate and cam timing advance
- gotta question for you guys
- decode 12 bolt
- flexplate question
- Fair price for TCI Street Fighter TH-350
- Fresh T350 takes a dump
- what type 4 speed have i found lots of numbers that i dont understand
- 2004r ID Question
- scatter shield price?
- Moroso Brute Strength question.....
- Rear Differential and Yoke
- stall converters
- How much torque to break traction.
- Transmission shop(s) in Az?
- th400, short tail vs long???????
- Worn Diff.
- 400 Turbo 1st gear lockup Help
- Will it fit??
- Replacing 12 bolt 4.11 Ring & Pinion With 3.55 Gears
- Computing final drive for the drags
- engine is in but doesn't mate with trans??
- .006 BACKLASH IN THE RING ??
- Which vehicles have good tranny coolers?
- frame bracket/pivot ball nut
- installing 2004r from turbo 400
- TH400/SB350 combo in a '68
- 200r4 which year and car to get one from?
- posi unit check
- shipping weight of 12 bolt rear
- M22 Super T10
- speedo gear terror!
- Clunking noise when I turn the wheels
- what to do with the 4 speed hump?if i use auto with console
- driveshaft swap
- pilot bearing.
- Speedo Cable?
- new radiator, no trans cooler!
- It's not a 700R4, it's a 200
- TH350 to 200-4R swap parts list
- What is the weight of a stock driveshaft?
- clutch won't release
- (wanted ) muncie side cover # 39552648
- powerglide still leaking fluid.. need some advice
- clutch slipping after warm?
- 67 12 bolt posi KY code? not in my books
- will the length of the driveshaft be same for 4speed and auto
- Fresh Turbo 400 slipping
- ok guys.....i'm confused and really need help here.....
- question on tranny coolers
- Transmission cooling lines correct thread sizes
- Counting gears 1-2-3 or 3-2-1 (Automatic)
- Manual trannies and braking
- Transmission install...AAAHHHHHH!!!!
- More on the floor
- rear end ratio?
- New Tremec topic
- New modulator fixed my broke TH350
- Which 10 bolt do I have?
- need info on speedometer gears in tranny
- 4spd noise in neutral
- tranny yoke sticking out too far???
- 12 bolt carriers
- Picked up new 700r4 !!
- u joint ??
- Hurst Shifter??
- Tranny 4 or 5 speed HP ratings for new BBC
- th350 cracked bellhousing
- Need a good tranny-converter-flexplate combo
- Tremec TKO-500/600 Update
- blew the muncie...what to do?
- Will Chevelle and Pontiac cross member interchange
- Rear axle widths?
- The numbers on my th400
- Rear-end and tranny questions for future reference
- Rear Diff needed
- 200-4R Dipstick tube and linkage question
- tranny fluid
- 8.5 10 bolt interchange???
- Nuts and Bolts with Converter?
- Power Trax ??????
- 4spd shifter boot question
- governor "calibration" @ 55 etc or stop the same?
- Where does the trans temp gauge go??
- how does this kickdown work???
- TH350 leaks under pressure
- 65 malibu, muncie, Hurst question
- THM400 Crossmember
- True trac
- Should I be expecting something soon?
- Transmission
- Remove and replace pinion yoke
- No place to hook 200 4R tv cable to my quadrajet
- Keep missing 1-2 shift
- Possible TH350 Problem?
- THM-375?
- TCI 400 not shifting. Need Help!
- Tremec noisy?
- posi question
- th350 first gear binding
- Help Please...Any ideas???
- Sprag?
- B&M Holeshot 2000 experience?
- Transmission and Rear End Combo
- help with 12 bolt question
- How to check if convertor is good
- Modulator for a TH350
- Converter Help
- Posi unit identify
- What kind of tranny is this?
- Convertor bolt question
- Auto on the coloumn ?
- I broke something in diff.
- Monster motorsports 4L60
- tough question(i think)
- Speedo gear and drive gear question
- decode rear end
- detent switch on 67 T 400
- 700R4 SWAP CORRECT FLYWHEEL
- electric lock up
- rearend
- BGH a question for you
- Auto trans Questions
- shift kit install
- SWAP 350 for 700R in 68 Chevelle 402
- Trans speeds and gas mileage
- Gone until Sunday!
- Engine under heavy load, problems ensue
- Correct tailhousing for 66 Chevelle muncie 4spd
- Muncie tailshaft bushing
- Manual auto
- 700 FLYWHEEL COVER WHAT FITS ?
- Trans Fluid
- Tranny dipstick for 200R
- Powertrax Installed
- 12 bolt rear end swap from cutlass
- New driveshaft needed?
- How to disconnect TV cable in 700R4??
- Transmission woes
- kickdown solenoid TH400
- Strange trans yoke
- 700r trans problems
- crack where line fitting is !!!!
- 200R4 tv cable adjustment
- removing a Hurst shift handle the easy way?
- bellhousing i.d.
- Muncie 3rd. gear downshift grind
- Auto to Standard Trans
- GEAR OIL ?
- 3 Gen F-body T5
- Granny low in a car?
- 8.5 10 bolt gear pattern help - pics
- Drive Shaft Length
- found these axels in my trunk
- Need input from the pros, 8" ford
- Not using GM posi additive
- Need help with 4spd install
- Testing Convertor possible?
- last half inch
- Leaking 12 bolt
- 12 bolt posi question
- transmission price check
- Choosing a clutch/pressure plate
- RICHMOND 6-SPEED
- 12 bolt posi chunk decode
- Will A Monte Rear End Fit in a chevelle
- Tremec TKO Update
- Traction Lock carriers, anyone using one? 28 spline or 31?
- question on tranny fluid
- major leak with turbo400
- Will a 10 bolt 73 Camaro ring & pinion fit my 65 10 bolt Chevelle?
- Clutch Pedal Pushrod Length
- Line Pressure
- TH350 fluid change question.....easy one for you guys...
- U Joints
- Recomended interchangeable book
- Trying to Id this 12 bolt
- turbo 400 shifter shaft seal
- 70 El Camino rear end bolt up to a 65 Chevelle?
- 12 bolt rear questions
- tourque specs?
- Wow, this is cool.
- 1-2 shift problems
- TH400 Kickdown & Neutral safety switch
- Best place to mount trans cooler on '70 model?
- How do trans coolers work?
- Shifter cable hole position?
|
Pages :
1
2
3
4
5
6
7
8
9
10
11
12
13
[14]
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
| ||